Product description
Y-strainers lose heat but also require periodic screen cleaning and sediment discharge, so fixed insulation is often damaged after maintenance. Type Y retains the original Silicone woven fiberglass, 40mm thickness and acid/steam resistance while aligning content with the official Flexinsul Y-strainer application.
Auxiliary flap allows clean-out or screen-cleaning access.
Protects workers from contact burns on metal caps.
Patterned for common Kitz, Yoshitake, Genebre strainers or custom site dimensions.
Reduces downtime and helps the insulation return correctly after maintenance.
Detailed technical specifications
Detailed technical specifications
| Brand | Flexinsul Jacket |
|---|
| Designed for | Y-Strainers |
|---|
| Size | DN15 | DN20 | DN25 | DN32 | DN40 | DN50 | ... | DN300 | Other |
|---|
| Material options | Rockwool | Ceramic | Aerogel | Silica | Other based on survey |
|---|
| Density | 80 kg/m³ | 96 kg/m³ | Other |
|---|
| Standard thickness | 25mm | 50mm | 75mm | 100mm | Other |
|---|
| This type operating range | -20°C to 400°C |
|---|
| This type material setup | Woven fiberglass armored with water-repelling Silicone |
|---|
| This type reference thickness | 40mm |
|---|
| Energy saving | Up to 95% heat-loss reduction under suitable design conditions |
|---|
| Outer shell | Silicone-coated fiberglass cloth: water-resistant, heat-resistant, chemical-resistant |
|---|
| Sewing thread | SS Core Flame-Resistant Thread |
|---|
| Silicone shell temperature | Up to 260°C. Higher-temperature material options available |
|---|
The specifications above are for initial consultation. During actual implementation, Anton Therm adjusts the design by peak temperature, indoor/outdoor conditions, humidity, chemicals, vibration and removal requirements.
Required audit information
Survey information required
Overview and close-up photos of the component, including opening/removal direction for maintenance.
DN/key dimensions, length, bend radius, flange, nozzles or equipment geometry.
Normal operating temperature, peak temperature, pressure and heat-up/cool-down cycle.
Environment: indoor/outdoor, UV, steam, oil, chemicals, vibration and washdown.
Inspection, cleaning, bolt-tightening, drain or actuator/sensor removal frequency.
Acceptance criteria: target touch temperature, sealing, closure strength, reusability and finish quality.
If drawings are not available, Anton Therm can guide minimum measurement points or survey on site for pattern development.
